QUESTION 195
A network engineer must connect two sites across a public network using a secure tunneling technology that supports multicast traffic. Which technology must be chosen?

QUESTION 196
An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported be the traffic policing feature? (Choose two.)

QUESTION 197
Exhibit:

Refer to the exhibit. An engineer is designing a Layer 2 campus network. The design must support fast convergence and leverage as much bandwidth as possible between layers. Distribution switches do support VSS; unfortunately, not all routing protocols are available for use due to license limitations. Which solution must the engineer choose?

QUESTION 198
An engineer must peer with an ISP for internet connectivity using BGP, initially, the engineer wants to receive only specific prefixes from the ISP and a default route. However, the solution must provide the flexibility to add prefixes in the future at short notice. The ISP has a two-week change process in place. Which route filtering solution must the engineer employ?

QUESTION 199
A company’s branch location uses redundant routers and links for connectivity to the headquarters. Also, to use the entire available bandwidth, the branch uses a dynamic routing protocol. An architect must design a multicast streaming solution to avoid RPF check failures because of the current network design. Which deployment model must the architect choose?

QUESTION 200
An engineer must design a VPN solution for a company that has multiple branches connecting to a main office.
What are two advantages of using DMVPN instead of IPsec tunnels to accomplish this task? (Choose two.)

QUESTION 201
What does a hierarchical EIGRP design help with? (Choose two.)

QUESTION 202
How are wireless endpoints registered in the HTDB in a Cisco SD-Access architecture?

QUESTION 203
In a Cisco SD-Access fabric, which node facilities connectivity between the fabric and networks external to the fabric?

QUESTION 204
Drag and drop the descriptions from the left onto the categories they apply to on the right.

QUESTION 205
An engineer must use YANG with an XML representation to configure a Cisco IOS XE switch with these specifications:
– IP address 10.10.10.10/27 configured on the interface
GigabitEthernet2/1/0
– connectivity from a directly connected host 10.10.10.1/27
Which YANG data model set must the engineer choose?

QUESTION 206
An engineer must use YANG with an XML representation to configure a Cisco IOS XE switch with these specifications:
IP address 10.10.10.10/27 configured on the interface GigabitEthernet2/1/0 connectivity from a directly connected host 10.10.10.1/27 Which YANG data model set must the engineer choose?
A)

B)

C)

D)

QUESTION 207
Refer to the exhibit. An engineer is designing a routing solution for a customer. The design must ensure that a failure of network 10.1.0.0/24, 10.1.2.0/24, 10.2.1.0/24, or 10.2.3.0/24 does not impact the core. It also requires fast convergence time during any link failover in the core or access networks.
Which solution must the engineer select?

QUESTION 208
Which control-plane technology allows the same subnet to exist across multiple network locations?

QUESTION 209
Which protocol is deployed through LAN automation to build node-to-node underlay adjacencies in SDA?

QUESTION 210
An engineer is designing an EIGRP network for a small branch site where there is only one Layer 3 router. The engineer wants the router to advertise the local LAN network to remote EIGRP neighbors without sending any unnecessary multicast messages on the local LAN. Which action should the engineer take?

QUESTION 211
Refer to the exhibit.

Refer to the exhibit. Which two solutions maximize the use of the links between the core and distribution layers? (Choose two.)

QUESTION 212
Refer to the exhibit. The full EIGRP routing table is advertised throughout the network. Currently, users experience data loss when any one link in the network fails. An architect optimizes the network to reduce the impact when a link fails.
Which solution should the architect include in the design?

QUESTION 213
Which design consideration must be made when dual WAN Edge routers are deployed at a branch site?

QUESTION 214
Which two tasks must you perform to configure DHCP snooping on a device? (Choose two.)

QUESTION 215

Refer to the exhibit. A customer needs to apply QoS to the network management traffic passing through the GigabitEthernet0/2 interface. All eight queuing classes are in use, so the new requirement must be integrated into the existing policy. Which solution must the customer choose?

QUESTION 216
What is the function of the multicast Reverse Path Forwarding check?

QUESTION 217
Refer to the exhibit. An architect is developing a solution to consolidate networks while retaining device redundancy. The routing protocol for the WAN routers must be open standard, ensure high availability, and provide the fastest convergence time.
Which solution must the design include?

QUESTION 218
In a multicast network, which condition must be met for an RPF check to be performed on the RP address’?