[Nov-2026] H12-811_V2.0 Questions – Truly Beneficial For Your Huawei Exam [Q46-Q61]
H12-811_V2.0 | Huawei

[Nov-2026] H12-811_V2.0 Questions – Truly Beneficial For Your Huawei Exam [Q46-Q61]

H12-811_V2.0 | Huawei
Rate this post

[Nov-2026] H12-811_V2.0 Questions – Truly Beneficial For Your Huawei Exam

Download Huawei H12-811_V2.0 Sample Questions

Huawei H12-811_V2.0 Exam Syllabus Topics:

Section Weight Objectives
IP Technology Basics 25% – IPv4 addressing, subnetting
– IPv6 basics
– IP routing basics and forwarding
– Static routing, OSPF fundamentals
WLAN Technology Basics 10% – WLAN architecture and working principles
– Basic WLAN configuration
– 802.11 standards and WLAN components
Network Security and Services 15% – AAA and basic security technologies
– DHCP, DNS, FTP, Telnet services
– ACL, NAT principles and configuration
Data Communication Network Basics 10% – ARP, TCP/UDP principles
– VRP system basics and operations
– OSI and TCP/IP protocol models
– Data forwarding process
– Basic network concepts and architecture
– Campus network basics
Typical Campus Networking Solution 5% – End-to-end networking scenarios
– Campus network design and integration
Network O&M and Troubleshooting 10% – Fault diagnosis and troubleshooting methods
– Network monitoring and management tools
Ethernet Technology Basics 20% – Ethernet standards and switch principles
– VLAN, STP, RSTP principles and configuration
– Link aggregation and stacking technologies
Data Center Network Basics 5% – Data center architecture overview
– Basic data center networking technologies

 

Q46. On a switched network where STP is enabled on all devices, when a downstream device detects a topology change, it continuously sends configuration BPDUs to the upstream device until the root bridge is informed of the topology change.

 
 

Q47. What is the main function of the DNS protocol?

 
 
 
 

Q48. After the root bridge is elected on an STP network, which of the following parameters may be compared by ports on non-root bridge nodes to elect the root port? (Select all that apply)

 
 
 
 

Q49. PC1 and PC2 are connected to the same switch, but they cannot learn each other’s ARP information. This may be caused by incorrect VLAN configuration on the switch.

 
 

Q50. On the network shown in the figure, the administrator creates Eth-Trunk 1 in manual mode on SW1 and SW2, and adds GE1/0/1 and GE1/0/2 on both switches to the Eth-Trunk. After the administrator runs the display interface brief command on SW1, the administrator finds that GE1/0/1 is Up and GE1/0/2 is Down. Which of the following statements is true about this scenario?

 
 
 
 

Q51. If the neighbor relationship between R1 and R2 has reached the Full state in OSPF, which of the following statements are true? (Select all that apply)

 
 
 
 

Q52. What is the broadcast address of the network that contains a host with IP address
192.168.1.147/28?

 
 
 
 

Q53. Which of the following information is displayed when an entered command is incomplete on the Versatile Routing Platform (VRP)?

 
 
 
 

Q54. Which of the following information is displayed when an entered command is incomplete on the Versatile Routing Platform (VRP)?

 
 
 
 

Q55. IEEE 802.11 is the standard for WLANs. Which of the following 802.11 protocols uses 1024-QAM modulation?

 
 
 
 

Q56. Which of the following phases are required for establishing a connection between an SSH server and an SSH client? (Select all that apply)

 
 
 
 

Q57. According to the following routing table, it can be inferred that the IP address of VLANIF 2 on R1 is 10.0.12.1/24.
[R1] display ip routing-table
Proto: Protocol Pre: Preference
Route Flags: R – relay, D – download to fib, T – to vpn-instance, B –
black hole route
Routing Table: public
Destinations: 10 Routes : 10
Destination/Mask Proto Pre Cost Flags NextHop Interface
10.0.12.0/24 Direct 0 0 D 10.0.12.1 Vlanif2
10.0.12.1/32 Direct 0 0 D 127.0.0.1 Vlanif2
10.0.12.255/32 Direct 0 0 D 127.0.0.1 Vlanif2
10.0.21.0/24 Direct 0 0 D 10.0.21.1 Vlanif3
10.0.21.1/32 Direct 0 0 D 127.0.0.1 Vlanif3
10.0.21.255/32 Direct 0 0 D 127.0.0.1 Vlanif3

 
 

Q58. Which of the following IP addresses cannot be configured for a host by default?

 
 
 
 

Q59. Which of the following phases are required for establishing a connection between an SSH server and an SSH client? (Select all that apply)

 
 
 
 

Q60. After a switch restarts, static MAC address entries saved on the switch remain in the MAC address table.

 
 

Q61. Which of the following commands can be used to check OSPF routes in the global routing table?

 
 
 
 

Truly Beneficial For Your Huawei Exam: https://www.examcollectionpass.com/Huawei/H12-811_V2.0-practice-exam-dumps.html

         

Related Links: myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below