[Oct-2022] Pass JN0-663 Exam in First Attempt UpdatedJN0-663 ExamcollectionPass Exam Question [Q17-Q34]

NO.17 Exhibit:

You notice an inconsistency between the routing table and the OSPF database, as shown in the exhibit.
What are two reasons for this behavior? (Choose two.)

NO.18 Exhibit:

Referring to the exhibit, which two statements about route reflectors are correct? (Choose two.)

NO.19 Click the Exhibit button.

A network administrator is investigating why traffic from R2 is not being forwarded to R1 Referring to the show isis database command output shown in the exhibit, what is causing this problem on the network?

NO.20 Which two statements about IS-IS are correct? (Choose two.)

NO.21 What occurs when a router running IS-IS receives an LSP with the overload bit set?

NO.22 Exhibit:

Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)

NO.23 You are creating an LDP-signaled Layer 2 circuit between two sites. Site1 and Site2 use different VLAN IDs to connect to your PE devices In this scenario, which encapsulation type must be used on the logical interfaces?

NO.24 Exhibit.

You manage an MX Series device which includes the configuration shown in the exhibit Traffic marked with DSCP 000011 is entering the ge-1/0’4 interface at 102 Mbps The traffic exits the device on the ge-1 ‘0/5 interface No other traffic is transiting the router In this scenario what happens to traffic exceeding 100 Mbps?

NO.25 Exhibit:

The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer
2 VPN that uses the BGP session are unable to communicate.
What is the problem in this situation?

NO.26 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NO.27 Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NO.28 Exhibit:

Referring to the exhibit, external routes are being received at R1. These routes must appear on R5.
Which action will produce this result?

NO.29 Exhibit:

You are troubleshooting an issue where R1 is no longer receiving the default IS-IS route from R3.
Referring to the exhibit, which action would you take to solve the problem?

NO.30 Exhibit:

Referring to the exhibit, you have recently established a Layer 3 VPN between PE-1 and PE-2, connecting the two CE sites. Rowing information is being shared between sites and the customer has two-way communication After adding this VPN to your core network, PE-1 and PE-2 are no longer able to forward traffic to the Internet.
In this scenario, what is the problem?

NO.31

Referring to the exhibit, which OSPFv3 configuration is implemented on router R1?
set protocols ospf3 area 0.0.0.0 interface ge-0/0/0.0

NO.32

You have an established Layer 3 VPN between two PE devices. You are asked to only send certain routes from PE-1 over the VPN to the remote site while maintaining all the routes on the PE-1 device. You created a policy that matches the specific routes and then tags these routes with the appropriate target community values.
In this scenario, which configuration changes must be made to satisfy the requirement?

NO.33 Exhibit.

You have the LDP signaled VPLS topology as shown in the exhibit CE-B at Site-2 is multihomed to both PE-2 and PE-3 In this scenario where would you configure loop prevention?

NO.34 You recently deployed CoS-based forwarding in your network, which uses OSPF as its IGP You notice that the forwarding of traffic has not changed and is not following the path indicated within your configuration.
In this scenario, which statement explains this behavior?